LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - Off Vehicle >> Piston, Connecting Rod, And Bearing Removal

Piston, Connecting Rod, And Bearing Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Connecting Rod Cap
    GM2742576Courtesy of GENERAL MOTORS COMPANY
  1. Rotate the crankshaft to a position where the connecting rod bolts are the most accessible.
  2. Mark the connecting rod and cap with the cylinder position. Also mark their orientation. This will ensure the caps and connecting rods are re-assembled properly.
  3. Remove any ridge at the top of the cylinder bore to avoid damage to the piston ring lands.
  4. Remove and discard the connecting rod bolts (2).
  5. Remove the connecting rod cap (1).
    6. Fig 2: Piston And Connecting Rod Assembly
    GM2742577Courtesy of GENERAL MOTORS COMPANY
  6. Remove the piston and connecting rod assembly (1).
scientia non olet · About LEMON Manuals