Intake Camshaft and Components Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the camshaft front bearing cap bolts (2).
- Locate the pry points (3) on the camshaft front bearing cap.
- When using the pry points to remove the front bearing cap, use a protective material between the camshaft lobes, the cylinder head flange, and pry tool.
- Use 2 pry tools simultaneously to pry the upper front bearing cap away from the lower bearing cap evenly.
- Using suitable pry tools, remove the camshaft front bearing cap (1)
- Mark the intake camshaft rear cap to ensure it is installed in the same position. Remove the intake camshaft bearing rear cap bolts (1) and cap (4).
- Mark the camshaft caps (2) to ensure they are installed in the same position.
- Remove the intake camshaft cap bolts (1).
- Remove the camshaft caps (2).
- Remove the intake camshaft (3).
- Remove the intake camshaft roller finger followers (1).
- Remove the hydraulic lash adjusters (1).
NOTE:
NOTE:
Loosen each bolt on each cap one turn at a time until there is no spring tension pushing on the camshaft.
NOTE:
Keep all of the roller finger followers and hydraulic lash adjusters in order so that they can be reinstalled in their respective locations.