LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - Off Vehicle >> Intake And Exhaust Camshaft, Bearing Cap, And Lash Adjuster Removal >> Exhaust Camshaft and Components Removal

Exhaust Camshaft and Components Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Camshaft Caps
    GM2742567Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Loosen each bolt on each cap one turn at a time until there is no spring tension pushing on the camshaft.

  1. Mark camshaft caps (2) to ensure they are installed in the same position.
  2. Remove the exhaust camshaft cap bolts (3).
  3. Remove the camshaft caps (2) ensuring they are marked and refitted in same position on assembly.
  4. Remove the exhaust camshaft (1).
    5. Fig 2: Exhaust Camshaft Roller Finger Followers
    GM2742569Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Keep all of the roller finger followers and hydraulic lash adjusters in order so that they can be reinstalled in their respective locations.

  5. Remove the exhaust camshaft roller finger followers (1).
    6. Fig 3: Hydraulic Lash Adjusters
    GM2742570Courtesy of GENERAL MOTORS COMPANY
  6. Remove the hydraulic lash adjusters (1).
    7. Fig 4: Camshaft Bearing Lower Front Cap
    GM2742572Courtesy of GENERAL MOTORS COMPANY
  7. Remove the camshaft bearing lower front cap (1).
scientia non olet · About LEMON Manuals