LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - Off Vehicle >> Exhaust Manifold Removal

Exhaust Manifold Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exhaust Manifold Heat Shield Bolts
    GM2769470Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    In the event that a bolt breaks upon removal of components, perform an extraction of the broken bolt.

  1. Remove the exhaust manifold heat shield bolts (2).
  2. Remove the exhaust manifold heat shield (1).
    3. Fig 2: Exhaust Manifold Brace Nuts
    GM2769471Courtesy of GENERAL MOTORS COMPANY
  3. Remove the exhaust manifold brace nuts (1) and discard.
  4. Remove the exhaust manifold brace bolts (3).
  5. Remove the exhaust manifold brace (2).
    6. Fig 3: Exhaust Manifold And Cylinder Head Bolts
    GM2769473Courtesy of GENERAL MOTORS COMPANY
  6. Remove and discard the exhaust manifold to cylinder head bolts (3).
  7. Remove the exhaust manifold (1).
  8. Remove and discard the exhaust manifold gasket (2).
  9. Clean all of the sealing surfaces.
scientia non olet · About LEMON Manuals