LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - Off Vehicle >> Engine Front Cover Removal

Engine Front Cover Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Accessory Drive Belt Tensioner And Bolt
    GM2726756Courtesy of GENERAL MOTORS COMPANY
  1. Remove the accessory drive belt tensioner bolt (1).
  2. Remove the accessory drive belt tensioner (2).
    3. Fig 2: Engine Front Cover, Bolts And Front Oil Seal
    GM4035240Courtesy of GENERAL MOTORS COMPANY
  3. Remove the engine front cover bolts (2 - 8, 10).
  4. Discard bolts 3, 5, and 6.
    5. NOTE:

    Inspect around the edges of the cover for pry locations. Use a suitable tool at the pry locations to assist with removal of the cover.

  5. Remove the engine front cover (1).
  6. Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant 
  7. Clean and Inspect the engine front cover mating surface.
  8. Remove the front oil seal (9) with an appropriate tool, and discard.
scientia non olet · About LEMON Manuals