Camshaft Cover Component Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Cover Component

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Vacuum Pump Gasket NOTE: Use a NEW gasket.
2	Vacuum Pump
3	Vacuum Pump Bolt tighten 10 N.m (89 lb in)
4	Vacuum Pump Bolt tighten 10 N.m (89 lb in)
5	Camshaft Position Actuator Solenoid Valve - Exhaust
6	Camshaft Position Actuator Solenoid Valve Bolt tighten 10 N.m (89 lb in)
7	Camshaft Position Actuator Solenoid Valve - Intake
8	Camshaft Position Actuator Solenoid Valve Bolt tighten 10 N.m (89 lb in)
9	Ignition Coil Procedure Inspect the inside of the ignition coil rubber boot for a thin, even coat of grease. If there is no grease present or additional grease is necessary, apply a thin coating of dielectric grease evenly to the inside of the ignition coil rubber boot, up to a depth of 15 mm from the end of the boot. Refer to Adhesives, Fluids, Lubricants, and Sealers . Remove any excess grease from around the end of the boot, and ensure there is not an excessive amount within the boot.
10	Ignition Coil Bolt tighten 10 N.m (89 lb in)
11	Engine Lift Front Bracket
12	Engine Lift Front Bracket Bolt tighten 25 N.m (18 lb ft)
13	Engine Lift Rear Bracket
14	Engine Lift Rear Bracket Bolt tighten 25 N.m (18 lb ft)
15	Oil Level Indicator
16	Camshaft Cover Heat Shield
17	Camshaft Cover Heat Shield Bolt NOTE: An additional bolt retains the camshaft cover heat shield and the turbocharger coolant return pipe. tighten 10 N.m (89 lb in)
18	Engine Coolant Air Bleed Pipe O-Ring
19	Engine Coolant Air Bleed Pipe
20	Engine Coolant Air Bleed Pipe Bolt tighten 10 N.m (89 lb in)