Automatic Transmission Flex Plate Removal

Special Tools 

EN-51760  Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools .

Fig 1: Starter Motor Bolts
Courtesy of GENERAL MOTORS COMPANY
1. To prevent crankshaft rotation, install EN-51760  holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flywheel.
Fig 2: Automatic Flex Plate Attaching Bolts
Courtesy of GENERAL MOTORS COMPANY
2. Remove and discard the flywheel attaching bolts (1).
3. Remove the flywheel (2).
4. Remove EN 51760  holding tool.