Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON.
Verify the parameters listed below do not display Malfunction when commanding the Engine Oil Pressure Control Solenoid Valve On/Decrease and Off/Increase with a scan tool.
- Engine Oil Pressure Control Solenoid Valve Control Circuit Low Voltage Test Status
- Engine Oil Pressure Control Solenoid Valve Control Circuit Open Test Status
- Engine Oil Pressure Control Solenoid Valve Control Circuit High Voltage Test Status
- If Malfunction is displayed
  Refer to Circuit/System Testing.
- Go to next step: If Malfunction is not displayed
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing.
- Go to next step: If the DTC is not set
All OK.