LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Park Release Lever And Park Pawl Actuator Installation >> Manual Shift Shaft and Park Release Lever Installation

Manual Shift Shaft and Park Release Lever Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Manual Shift Shaft And Park Release Lever
GM4378860Courtesy of GENERAL MOTORS COMPANY
Manual Shift Shaft and Park Release Lever Installation

Callout Component Name
1 Park Pawl Actuator
2 Park Release Lever
3 Manual Shift Shaft
NOTE:

Lubricate the shaft with ATF to prevent damage to the manual shift shaft seal during installation.
4 Manual Shaft Detent Lever Hub Pin
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Install a NEW manual shaft detent lever hub pin.
  2. Install the manual shaft detent lever hub pin to correct height.

Specification 
7.9 mm (0.38 in) (a)
scientia non olet · About LEMON Manuals