1-2-3-4-5-6 Clutch Piston Housing Retaining Ring, Output Sun Gear and 1-Reverse and 1-2-3-4-5-6 Clutch Piston Housing Removal
WARNING: This page is about a different variant/trim than selected.
Fig 1: 1-2-3-4-5-6 Clutch Piston Housing Retaining Ring, Output Sun Gear And 1-Reverse And 1-2-3-4-5-6 Clutch Piston Housing
1-2-3-4-5-6 Clutch Piston Housing Return Ring, Output Sun Gear and 1-Reverse and 1-2-3-4-5-6 Clutch Piston Housing Removal
| Callout | Component Name |
|---|---|
| 1 | 1-2-3-4-5-6 Clutch Piston Housing Return Ring
WARNING:
The retainer is under tension. Use care when removing or installing the retainer. Personal injury could result.
CAUTION:
Use caution during removal or installation of the retainer ring to avoid damage to the case machined surface in the park pawl area. Burrs or raised edges on the case machined surface can cause the park pawl to bind and prohibit it from engaging the park gear.
NOTE:
Remove one end of the retainer using DT-28585 snap ring remover or equivalent and work the retainer out of the case groove. Special Tool DT-28585 Snap Ring Remover or equivalent Equivalent regional tools: Special Tools |
| 2 | Output Sun Gear |
| 3 | 1-Reverse and 1-2-3-4-5-6 Clutch Piston Housing |