LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Removal (Without ETRS) >> Control Valve Solenoid Body Wiring Harness Removal

Control Valve Solenoid Body Wiring Harness Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Control Valve Solenoid Body Wiring Harness
GM4405088Courtesy of GENERAL MOTORS COMPANY
Control Valve Solenoid Body Wiring Harness Removal

Callout Component Name
1 Control Valve Body Bolt (Qty: 3)
2 Control Valve Solenoid Body Bolt
3 Automatic Transmission Wiring Harness

Procedure

  1. Ensure you disconnect all the connectors from the valve body.
  2. On-Vehicle the Variable Feed Solenoid Clutch Accumulator Piston and Spring may fall out. Refer to Control Valve Body Assembly Disassemble (without ETRS) 
NOTE:

The bolts are captured with harness.
4 Automatic Transmission Wiring Harness Seal
NOTE:

Remove and DISCARD the seal.
scientia non olet · About LEMON Manuals