Control Valve Body Installation
WARNING: This page is about a different variant/trim than selected.
Courtesy of GENERAL MOTORS COMPANY Control Valve Body Installation
| Callout |
Component Name |
| 1 |
1-2-3-4 Low and Reverse Clutch Fluid Passage Seal (Qty: 5)
Procedure
Install NEW seals. Do NOT reuse old seals. |
| 2 |
Control Valve Body |
| 3 |
Control Valve Body Bolt (Qty: 5)
Tighten in sequence
8 N.m (71 lb in) |