Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify the condition does not exist: Incorrect fluid level or condition - Transmission - Refer to Transmission Fluid Level and Condition Check
- If a condition exists
  Repair or replace as necessary.
- Go to next step: If no condition exists
DTCs related to the following system/component = Not Set
- B315A Transmission Range Control Valve 1 Position Switch
- B315B Transmission Range Control Valve 2 Position Switch
- B316 Transmission Park Valve Position Switch
- If a related DTC is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If a related DTC is not set
Ignition - On/Vehicle - In Service Mode
Clear DTCs
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P187E, P18AA, P18AB, P18AC, P18AD, P18AE, P27EC, P27F0, P27EB, P27ED, P27EE, P27EF, P27F1, P27F2 is not set.
- If DTC P27EB, P27ED, P27EE, P27EF, P27F1, P27F2 is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle
- If DTC P187E, P18AA, P18AB, P18AC, P18AD, P18AE, P27EC, P27F0 is set
  Refer to Diagnostic Fault Information
- Go to next step: If none of the DTCs are set
All OK.