LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Specifications >> Fastener Specifications

Fastener Specifications

WARNING: This page is about a different variant/trim than selected.
Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Application
Air Conditioning Compressor Hose Seal
Camshaft Housing Gasket
Catalytic Converter Gasket
Charge Air Bypass Valve Vacuum Hose Seal
Crankshaft Front Oil Seal
Crankshaft Rear Oil Seal
Cylinder Head Gasket
Engine Cooler Outlet Pipe Seal
Engine Core Hole Plug
Engine Oil Level Indicator Switch O-Ring Seal
Exhaust Gas Recirculation Cooler Housing Gasket
Exhaust Gas Recirculation Cooler Outlet Pipe Seal
Exhaust Gas Recirculation Cooler Pipe Gasket
Exhaust Gas Recirculation Valve Gasket
Exhaust Gas Recirculation Valve Seat Gasket
Exhaust Manifold Gasket
Exhaust Pressure Differential Sensor Pipe Clamp
Fuel Injection Fuel Return Hose Clamp
Fuel Injection Pump Seal Ring
Fuel Injector Fuel Return Hose Clamp
Fuel Injector Gasket
Fuel Injector Return Hose Clip
Fuel Return Hose Clamp
Intake Manifold Gasket
Oil Cooler Adapter Gasket
Oil Filter Cap Bolt Gasket
Oil Filter Cap O-Ring
Oil Filter Cap Seal
Oil Filter Seal
Oil Pan Drain Plug Gasket
Power Brake Booster Inlet Hose Connector Fitting Seal
Throttle Body Assembly Gasket
Timing Chain Lower Cover Gasket
Turbocharger Coolant Feed And Return Pipe Bracket Gasket
Turbocharger Coolant Feed Pipe Clamp
Turbocharger Coolant Feed Pipe Gasket
Turbocharger Gasket
Turbocharger Oil Feed Pipe Gasket
Turbocharger Oil Return Pipe Gasket
Valve Stem Oil Seal
Water Pump Seal
Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Application Specification
Metric (English)
Automatic Transmission Flex Plate Bolt
  • First Pass:
 60 N.m (44 lb ft)
  • Final Pass:
 45 degrees
Catalytic Converter Clamp
  • First Pass:
 6 N.m (53 lb in)
  • Final Pass:
 25 N.m (18 lb ft)
Connecting Bearing Cap Bolt
  • First Pass:
 25 N.m (18 lb ft)
  • Final Pass:
 110 degrees
Crankshaft Pulley Bolt
  • First Pass:
 50 N.m (37 lb ft)
  • Final Pass:
 45 degrees
Cylinder Head Bolt
  • First Pass:
 50 N.m (37 lb ft)
  • Second Pass:
 90 degrees
  • Third Pass:
 90 degrees
  • Final Pass:
 90 degrees
Cylinder Head Outer Bolt
  • First Pass:
 20 N.m (15 lb ft)
  • Final Pass:
 45 degrees
Engine Mount Bracket Bolt
  • First Pass:
 58 N.m (43 lb ft)
  • Final Pass:
 60 - 75 degrees
Exhaust Manifold Bolt
  • First Pass:
 27 N.m (20 lb ft)
  • Second Pass:
 27 N.m (20 lb ft)
  • Final Pass:
 27 N.m (20 lb ft)
Fuel Injector Bracket Bolt
  • First Pass:
 10 N.m (89 lb in)
  • Final Pass:
 60 degrees
Fuel Injection Fuel Feed Pipe - Fuel Injection Pump To Fuel Rail 28 N.m (21 lb ft)
Fuel Injection Fuel Feed Pipe - Fuel Rail To Fuel Injector 28 N.m (21 lb ft)
Fuel Injection Fuel Rail Fuel Pressure Sensor 35 N.m (26 lb ft)
Main Bearing Bolt
  • First Pass:
 50 N.m (37 lb ft)
  • Second Pass:
 90 degrees
  • Final Pass:
 90 degrees
Oil Pump Sprocket Bolt
  • First Pass:
 25 N.m (18 lb ft)
  • Final Pass:
 60 degrees
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal. 
Application Specification
Metric (English)
Air Cleaner Outlet Duct Clamp 3.5 N.m (31 lb in)
Air Conditioning Compressor Bolt 22 N.m (16 lb ft)
Air Conditioning Compressor Hose Bolt 22 N.m (16 lb ft)
Air Conditioning Compressor Nut 22 N.m (16 lb ft)
Camshaft Housing Bolt 10 N.m (89 lb in)
Camshaft Position Sensor Bolt 10 N.m (89 lb in)
Camshaft Rear Cap Bolt 25 N.m (18 lb ft)
Camshaft Sprocket Bolt 25 N.m (18 lb ft)
Catalytic Converter Bracket Nut 22 N.m (16 lb ft)
Catalytic Converter Heat Shield Bolt 9 N.m (80 lb in)
Charger Air Bypass Valve Vacuum Hose Bracket Bolt 10 N.m (89 lb in)
Crankshaft Position Sensor Bolt 10 N.m (89 lb in)
Diesel Fuel Separator Bolt 10 N.m (89 lb in)
Drive Belt Idler Pulley Bolt 58 N.m (43 lb ft)
Drive Belt Tensioner Bolt 55 N.m (41 lb ft)
Engine Block Coolant Drain Hole Plug 65 N.m (48 lb ft)
Engine Block Oil Gallery Plug 65 N.m (48 lb ft)
Engine Block Stud 20 N.m (15 lb ft)
Engine Coolant Temperature Sensor 33 N.m (24 lb ft)
Engine Cooler Outlet Pipe Bolt 25 N.m (18 lb ft)
Engine Lift Bracket Bolt 58 N.m (43 lb ft)
Engine Oil Heater Bolt 9 N.m (80 lb in)
Engine Oil Level Indicator Switch Bolt 10 N.m (89 lb in)
Engine Oil Pressure Sensor 35 N.m (26 lb ft)
Engine Oil Pressure Switch 35 N.m (26 lb ft)
Exhaust Camshaft Bearing Cap Bolt 10 N.m (89 lb in)
Exhaust Gas Recirculation Cooler Bolt 25 N.m (18 lb ft)
Exhaust Gas Recirculation Cooler Outlet Pipe Bolt 10 N.m (89 lb in)
Exhaust Gas Recirculation Cooler Temperature Sensor 45 N.m (33 lb ft)
Exhaust Gas Recirculation Pipe Bolt 10 N.m (89 lb in)
Exhaust Gas Recirculation Vacuum Regulator Solenoid Valve Bolt 7 N.m (62 lb in)
Exhaust Gas Recirculation Valve Bolt 10 N.m (89 lb in)
Exhaust Particulate Sensor Control Module Bracket Bolt 9 N.m (80 lb in)
Exhaust Pressure Differential Sensor Bolt 9 N.m (80 lb in)
Exhaust Pressure Differential Sensor Pipe Bracket Bolt 9 N.m (80 lb in)
Exhaust Temperature Sensor 45 N.m (33 lb ft)
Exhaust Temperature Sensor Electrical Connector Bracket Bolt 9 N.m (80 lb in)
Exhaust Temperature Wiring Harness Bracket Bolt 10 N.m (89 lb in)
Fuel Injection Fuel Feed Pipe Bracket Bolt 9 N.m (80 lb in)
Fuel Injection Fuel Pump Bolt 25 N.m (18 lb ft)
Fuel Injection Fuel Rail Bolt 25 N.m (18 lb ft)
Fuel Injection Fuel Rail Fuel Pressure Sensor Wire Bracket Bolt 9 N.m (80 lb in)
Fuel Injection Fuel Rail Pressor Sensor Wiring Harness Bracket Bolt 9 N.m (80 lb in)
Fuel Injection Fuel Return Pipe Bracket Bolt 7 N.m (62 lb in)
Fuel Injection Pipe Bracket Bolt 9 N.m (80 lb in)
Fuel Injection Pump Driven Sprocket Nut 64 N.m (47 lb ft)
Generator Bolt 22 N.m (16 lb ft)
Glow Plug 16.5 N.m (12 lb ft)
Heated Oxygen Sensor 45 N.m (33 lb ft)
Intake Air Pressure and Temperature Sensor Bolt 1.6 N.m (14 lb in)
Intake Camshaft Bearing Cap Bolt 10 N.m (89 lb in)
Intake Manifold Bolt 12 N.m (106 lb in)
Intake Manifold Brace Bolt 10 N.m (89 lb in)
Lower Crankcase Bolt 34 N.m (25 lb ft)
Nitrogen Oxides Sensor 50 N.m (37 lb ft)
Nitrogen Oxides Sensor Control Module Nut 9 N.m (80 lb in)
Oil Cooler Bolt 25 N.m (18 lb ft)
Oil Filter Cap 25 N.m (18 lb ft)
Oil Filter Cap Bolt 10 N.m (89 lb in)
Oil Pan Baffle Bolt 10 N.m (89 lb in)
Oil Pan Bolt 25 N.m (18 lb ft)
Oil Pan Drain Plug 25 N.m (18 lb ft)
Oil Pump Bolt 25 N.m (18 lb ft)
Oil Pump Drive Chain Tensioner Bolt (M6) 10 N.m (89 lb in)
Oil Pump Drive Chain Tensioner Bolt (M8) 25 N.m (18 lb ft)
Piston Oil Nozzle Bolt 10 N.m (89 lb in)
Piston Oil Nozzle Oil Control Solenoid Valve Bolt 10 N.m (89 lb in)
Power Brake Booster Inlet Hose Connector Fitting Bolt 10 N.m (89 lb in)
Starter Bolt 22 N.m (16 lb ft)
Thermostat Bypass Pipe Bolt 10 N.m (89 lb in)
Thermostat Bypass Pipe Bracket Bolt 10 N.m (89 lb in)
Throttle Body Assembly Bolt 10 N.m (89 lb in)
Timing Chain Idler Sprocket Bolt 25 N.m (18 lb ft)
Timing Chain Lower Cover Bolt 25 N.m (18 lb ft)
Timing Chain Lower Guide Bolt 10 N.m (89 lb in)
Timing Chain Tensioner Bolt 10 N.m (89 lb in)
Timing Chain Tensioner Shoe Bolt 25 N.m (18 lb ft)
Timing Chain Upper Cover Bolt 25 N.m (18 lb ft)
Timing Chain Upper Cover Sleeve 25 N.m (18 lb ft)
Timing Chain Upper Cover Sleeve Bolt 25 N.m (18 lb ft)
Timing Chain Upper Guide Bolt 11 N.m (97 lb in)
Turbocharger Coolant Feed Pipe Bolt 10 N.m (89 lb in)
Turbocharger Coolant Feed Pipe Bracket Nut 10 N.m (89 lb in)
Turbocharger Coolant Feed Pipe Hollow Bolt 25 N.m (18 lb ft)
Turbocharger Heat Shield Bolt 9 N.m (80 lb in)
Turbocharger Heat Shield Nut 9 N.m (80 lb in)
Turbocharger Nut 30 N.m (22 lb ft)
Turbocharger Oil Feed Pipe Bolt 10 N.m (89 lb in)
Turbocharger Oil Feed Pipe Bracket Bolt 10 N.m (89 lb in)
Turbocharger Oil Feed Pipe Hollow Bolt 25 N.m (18 lb ft)
Turbocharger Oil Return Pipe Bolt (M6) 10 N.m (89 lb in)
Turbocharger Oil Return Pipe Bolt (M8) 25 N.m (18 lb ft)
Turbocharger Wastegate Actuator Pipe Bracket Bolt 10 N.m (89 lb in)
Turbocharger Wastegate Actuator Pipe Nut 10 N.m (89 lb in)
Water Pump Bolt 25 N.m (18 lb ft)
scientia non olet · About LEMON Manuals