LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Timing Chain Lower Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove Timing Chain Upper Cover. Refer to Timing Chain Upper Cover Replacement .
  2. Remove Oil Pan. Refer to Oil Pan Replacement .
    3. Fig 1: Engine Lift Bracket And Bolt
    GM4421926Courtesy of GENERAL MOTORS COMPANY
  3. Install Engine Lift Bracket-Left Side (1)
    4. CAUTION:

    Refer to Fastener Caution

  4. Install and tighten Engine Lift Bracket Bolt (2) to 58 N.m (43 lb ft)
    5. Fig 2: Engine Lift Bracket And Bolt
    GM4421927Courtesy of GENERAL MOTORS COMPANY
  5. Install Engine Lift Bracket-Right Side (1)
  6. Install and tighten Engine Lift Bracket Bolt (2) to 58 N.m (43 lb ft).
  7. Remove Crankshaft Position Reluctor Ring. Refer to Crankshaft Position Sensor Reluctor Ring Replacement .
    8. Fig 3: Crankshaft Position Sensor, Bolt And Retainer Spring
    GM4421925Courtesy of GENERAL MOTORS COMPANY
  8. Remove Crankshaft Position Sensor Bolt (1)
  9. Remove the crankshaft position sensor retainer spring (3).
  10. Remove Crankshaft Position Sensor (2)
    11. Fig 4: Timing Chain Lower Cover, Bolts And Gaskets
    GM4421928Courtesy of GENERAL MOTORS COMPANY
  11. Remove the 11 timing chain lower cover bolts (1).
  12. Remove Timing Chain Lower Cover (2) - Use a suitable tool.
  13. Remove and DISCARD the gaskets. (3) (Qty: 2)
  14. Remove the crankshaft rear oil seal, if the timing chain lower cover reused.
scientia non olet · About LEMON Manuals