LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Oil And Power Brake Booster Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the automatic transmission flex plate. Refer to Automatic Transmission Flex Plate Replacement .
  2. Remove the oil pan. Refer to Oil Pan Replacement .
    3. Fig 1: Oil Pump Drive Chain Tensioner, Holding Tool And Oil Pan Bolt
    GM3275444Courtesy of GENERAL MOTORS COMPANY
  3. Tension the oil pump drive chain tensioner (3) with the EN-51142-2  holding tool (2) in arrow direction.
  4. Install the oil pan bolt (1) to fix the EN-51142-2  holding tool.
    5. Fig 2: Oil Pump Sprocket Bolt And Holding Tool
    GM3275445Courtesy of GENERAL MOTORS COMPANY
  5. Install the EN-51142-1  holding tool (1) to oil pump sprocket.
  6. Loosen the oil pump sprocket bolt (2) by counterhold at the EN-51142-1  holding tool.
    7. Fig 3: Oil Pump Sprocket And Bolt
    GM3275446Courtesy of GENERAL MOTORS COMPANY
  7. Unscrew the oil pump sprocket bolt (1) as far as possible.
  8. Detach the oil pump sprocket (2) from the oil and power brake booster pump shaft, use a suitable tool.
    9. Fig 4: Oil Pump Bolts, Sprocket, Sprocket Bolt, Oil/Power Brake Booster Pump And Gaskets
    GM3275447Courtesy of GENERAL MOTORS COMPANY
  9. Remove the 4 oil pump bolts (5).
  10. Remove the oil and power brake booster pump (4).
  11. Remove and DISCARD the oil pump sprocket bolt (3) from the oil pump sprocket (2).
  12. Remove the 2 oil and power brake booster pump gaskets (1).
scientia non olet · About LEMON Manuals