LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Engine Support Fixture >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Support Fixture Adapters And Engine Lift Brackets
    GM4328650Courtesy of GENERAL MOTORS COMPANY
  1. Remove the 2 EN-51007-6  adapters (1) from the 2 engine lift brackets (2).
    2. Fig 2: Engine Support Fixture Adapters And Front End Upper Tie Bar
    GM3701644Courtesy of GENERAL MOTORS COMPANY
  2. Loosen the 2 EN-51007-4  adapters (3).
    3. NOTE:

    A second technician is required.

  3. Remove the 2 EN-51007-3  adapters (4) with the EN-51007-5  adapters (6) from the EN-51007-1  adapter (1).
    4. Fig 3: Engine Support Fixture Adapters And Front Compartment Upper Side Rail
    GM3701642Courtesy of GENERAL MOTORS COMPANY
  4. Remove the EN-51007-1  adapter (3).
  5. Clean the contact surfaces from the EN-51007-5  adapters on the front end upper tie bar with solvent.
scientia non olet · About LEMON Manuals