Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine Support Fixture Adapters And Front Compartment Upper Side Rail

Courtesy of GENERAL MOTORS COMPANY

NOTE:

A second technician is required.

Install the EN-51007-1 adapter (3) with the EN-51007-7 adapters (2) between the bulge (1) of the front compartment upper side rail.

Fig 2: Engine Support Fixture Adapters And Front End Upper Tie Bar

Courtesy of GENERAL MOTORS COMPANY

NOTE:

The 2 feet of the rakes should be placed as far as possible in the direction as shown.

Install the EN-51007-3 adapters (4) to the EN-51007-1 adapter (1) with the EN-51007-5 adapters (6) on the front end upper tie bar (2, 5).

Fig 3: Engine Support Fixture Adapters

Courtesy of GENERAL MOTORS COMPANY

Tighten the EN-51007-3 adapters (2) to the EN-51007-1 adapter (1) by tighten it with the EN-51007-4 adapters (3).

Fig 4: Engine Support Fixture Adapters And Engine Lift Brackets

Courtesy of GENERAL MOTORS COMPANY

Install the 2 EN-51007-6 adapters (1) into the 2 engine lift brackets (2).
When the tool assembly EN-51007 support fixture is under load, adjust complete assemble and re-tighten ALL fasteners.