LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Oil Pressure Switch
    GM4199140Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to: Fastener Caution

  1. Install and tighten Engine Oil Pressure Switch (1) to 35 N.m (26 lb ft)
    2. Fig 2: Electrical Connectors, Wiring Harness And Clip
    GM4199139Courtesy of GENERAL MOTORS COMPANY
  2. Install Wiring Harness Clip (5)
  3. Connect the electrical connector:
    1. Starter (1)
    2. Fuel Injection Pump (2)
    3. Engine Oil Pressure Switch (3)
  4. Install Exhaust Front Pipe. Refer to Exhaust Front Pipe Replacement (LH7)
  5. Lower the vehicle.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
scientia non olet · About LEMON Manuals