LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Engine Oil Level Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Oil Level Indicator Switch, Bolts, O-Ring Seal And Electrical Connector
    GM4199144Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW O-ring seal. (2)
  2. Install Engine Oil Level Indicator Switch (3)
    3. CAUTION:

    Refer to: Fastener Caution

  3. Install and tighten Engine Oil Level Indicator Switch Bolts (4) (Qty: 3) to 10 N.m (89 lb in)
  4. Connect the electrical connector. (1)
  5. Fill the engine oil. Refer to Engine Oil and Oil Filter Replacement 
scientia non olet · About LEMON Manuals