LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - Off Vehicle >> Power Brake Booster Inlet Hose Connector Fitting Installation

Power Brake Booster Inlet Hose Connector Fitting Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Power Brake Booster Inlet Hose Connector Fitting And Components
    GM3216225Courtesy of GENERAL MOTORS COMPANY
  1. Install the power brake booster inlet hose connector fitting seal (6).
  2. Install the power brake booster inlet hose connector fitting (5).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the power brake booster inlet hose connector fitting bolt (7) to lower crankcase and tighten to 10 N.m (89 lb in).
  4. Install the 2 power brake booster inlet hose connector fitting bolts (4) and tighten to 10 N.m (89 lb in).
  5. Install the power brake booster inlet hose to turbocharger wastegate actuator vacuum control solenoid valve (2).
  6. Install the power brake booster inlet hose connector fitting bracket bolt (3) to the exhaust temperature sensor wiring harness bracket (1) and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals