Fuel Injector Removal
WARNING: This page is about a different variant/trim than selected.
Special Tools
- EN-51146-1-3 Sliding Hammer
- EN-51187 Injector Remover
Equivalent regional tools: Special Tools
WARNING:
Refer to Diesel/Gasoline Vapors Warning
WARNING:
Always wear safety goggles when working with fuel in order to protect the eyes from fuel splash.
NOTE:
- Be very thorough in terms of cleanliness when working in the fuel system. Malfunctions can also occur due to very small dirt particles. Prevent dirt from entering the fuel system by cleaning the hoses and plugging the pipes and lines upon removal. Store the components so that contaminants cannot enter.
- In order to reuse the injectors, mark the injectors so that they can be installed to the same cylinder.
- Remove and DISCARD Fuel Injector Bracket Bolts (1) (Qty: 4)
- Remove Fuel Injector Brackets (2) (Qty: 4)
- Pull out the 4 fuel injectors (2) with the EN-51187 remover (3) along with the EN-51146-1-3 sliding hammer (1).
- Remove Fuel Injectors (1) (Qty: 4)
- Remove and DISCARD Fuel Injector Washers (2) (Qty: 4)
- Protect the 4 fuel injector nozzles with suitable closure caps.
NOTE:
If the injector can not be removed by hand, use the EN-51187 remover and solve the Injector by turning at the hexagon.