LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - Off Vehicle >> Exhaust Gas Recirculation Cooler Housing Assemble

Exhaust Gas Recirculation Cooler Housing Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exhaust Gas Recirculation Cooler Housing And Components
    GM3283918Courtesy of GENERAL MOTORS COMPANY
  1. Install the exhaust gas recirculation vacuum regulator solenoid valve (8).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the 2 exhaust gas recirculation vacuum regulator solenoid valve bolts (9) and tighten to 7 N.m (62 lb in).
  3. Install the exhaust gas recirculation vacuum regulator hose (10).
  4. Install the exhaust pressure differential sensor (6).
  5. Install the exhaust pressure differential sensor bolt (7) and tighten to 9 N.m (80 lb in).
  6. Install a NEW exhaust gas recirculation valve seat gasket (2).
  7. Install a NEW exhaust gas recirculation valve gasket (3).
  8. Install the exhaust gas recirculation valve (4) to the exhaust gas recirculation valve cooler (1).
  9. Install the 2 exhaust gas recirculation valve bolts (5) and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals