Crankshaft Position Sensor Reluctor Ring Installation

Special Tools

• EN-652  Flywheel Holder
• EN-45059  Angle Meter

Equivalent regional tools: Special Tools 

Fig 1: Crankshaft Position Sensor Reluctor Ring And Pin
Courtesy of GENERAL MOTORS COMPANY
1. Install the crankshaft position sensor reluctor ring (1) by install the pin (2) in the correct hole of the engine block.
Fig 2: Automatic Transmission Flex Plate And Bolts
Courtesy of GENERAL MOTORS COMPANY
2. Install Automatic Transmission Flex Plate (1)
3. Install the 8 NEW automatic transmission flex plate bolts.

   Install NEW Automatic Transmission Flex Plate Bolts (2).

Fig 3: Flywheel Holder
Courtesy of GENERAL MOTORS COMPANY
4. Install the EN-652  flywheel holder (1) in order to fix the automatic transmission flex plate (2).
CAUTION:

Refer to Fastener Caution

CAUTION:

Refer to Torque-to-Yield Fastener Caution

5. Tighten the 8 automatic transmission flex plate bolts (3) crosswise to the following order:

   First Pass: 60 N.m (44 lb ft).

   Final Pass: 45 degrees, use the EN-45059  meter.

6. Remove the EN-652  flywheel holder.