LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - Off Vehicle >> Automatic Transmission Flex Plate Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Automatic Transmission Flex Plate And Bolts
    GM4199148Courtesy of GENERAL MOTORS COMPANY
  1. Install Automatic Transmission Flex Plate (1)
    2. NOTE:

    Install NEW bolts.

  2. Install Automatic Transmission Flex Plate Bolts (2) (Qty: 8)
    3. Fig 2: Flex Plate Holder
    GM4199147Courtesy of GENERAL MOTORS COMPANY
  3. Install the EN-652  holder (1) in order to fix the flex plate.
  4. Tighten the flex plate bolts crosswise in the following order:
      CAUTION:

      Refer to Fastener Caution

      CAUTION:

      Refer to Torque-to-Yield Fastener Caution

    1. First Pass: 60 N.m (44 lb ft)
    2. Final Pass: 45 degrees - EN-45059  meter
  5. Remove the EN-652  holder.
scientia non olet · About LEMON Manuals