LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Diagnostic Information And Procedures >> Oil Pressure Diagnosis And Testing >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  3. Remove the exhaust front pipe. Refer to Exhaust Front Pipe Replacement (LH7)
    4. Fig 1: Oil Pressure Sensor And Electrical Connector
    GM3283902Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the oil pressure sensor electrical connector (2) from the engine oil pressure sensor (1).
  5. Remove the oil pressure sensor (1).
scientia non olet · About LEMON Manuals