Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, observe the DTC information with a scan tool. Verify that DTCs U0073, U0100, or U0155 are not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If no DTC is set
- If any of the DTCs are set
- Ignition ON.
- Command the MIL with a scan tool ON and OFF.
- If the MIL does not turn ON and OFF
Refer to Circuit/System Testing.
- Go to next step: If the MIL turns ON and OFF
- If the MIL does not turn ON and OFF
- All OK.