Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify there are no DTCs set related to the following system/component:
- Reductant System
- B9 Ambient Air Temperature Sensor
- B17 Barometric Pressure Sensor
- B34 Engine Coolant Temperature Sensor
- B66 Intake Air Temperature Sensor
- B75C Multifunction Intake Air Sensor
- B115 Vehicle Speed Sensor
- B195 Nitrogen Oxides Sensor
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- If a related DTC is set
- Refer to: Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- Clear All Vehicle DTCs
- Ignition/Vehicle - Off - For greater than 2 min
- Engine - Running
- Perform the scan tool control function: Reductant System Tamper Service Bay Test
- Verify the procedure/test passes.
- If the procedure/test does not pass
Refer to Circuit/System Testing.
- If the procedure/test passes
All OK.
- If the procedure/test does not pass
- Go to next step: If a related DTC is not set
- Verify that DTC P2BAA is not set
- If the DTC is set
Refer to Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC is set
- All OK.