LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P205B - P2BAA) And Symptoms) >> Diagnostic Information And Procedures >> DTC P245A-P245D: Exhaust Gas Recirculation (EGR) Cooler Bypass Solenoid Valve >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve. Ignition ON.
  2. Connect a test lamp between the control circuit terminal 2 and B+.
  3. Verify the test lamp turns ON and OFF while commanding the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve ON and OFF with a scan tool.
    • If the test lamp is always ON 
    1. Ignition OFF, disconnect the X2 harness connector at the K20 Engine Control Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground.
      • If infinite resistance, replace the K20 Engine Control Module.
    • If the test lamp is always OFF 
    1. Ignition OFF, disconnect the harness connector at the K20 Engine Control Module.
    2. Test for less than 1 V between the control circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V
    3. Test for less than 2 Ω in the circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K20 Engine Control Module.
    • Go to next step: If the test lamp turns ON and OFF 
  4. Ignition ON, verify a test lamp illuminates between the voltage circuit terminal 1 and ground
    • If the test lamp does not illuminate 
    1. Ignition OFF, disconnect the harness connector at the K20 Engine Control Module.
    2. Test for infinite resistance between the ignition circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the ignition circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K20 Engine Control Module.
    • Go to next step: If the test lamp illuminates 
  5. Test or replace the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve.
scientia non olet · About LEMON Manuals