LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P205B - P2BAA) And Symptoms) >> Diagnostic Information And Procedures >> DTC P244C: Catalyst Low Temperature During Regeneration >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON.
  2. Verify that DTCs P113E, P2470, P2471, or P2472 are not set.
    • Go to next step: If none of the DTCs are set 
  3. Verify the integrity of the entire air induction system and exhaust system, including all turbocharger components by inspecting for the conditions listed below:
    • Leaks or restrictions in the hoses and pipes to the B136 Exhaust Differential Pressure Sensor
    • Damage to induction system components, including the turbocharger and charge air cooler
    • Loose or improperly installed components
    • Air flow restrictions
    • Exhaust leaks, including the mating surface between the turbocharger and exhaust manifold
    • If a condition is found 

      Repair as necessary

    • Go to next step: If no condition is found 
  4. Perform the Diesel Particulate Filter Service Regeneration.
  5. Verify the regeneration completed.
    • If the regeneration did not complete 

      Replace the Diesel Particulate Filter

    • Go to next step: If the regeneration completed 
  6. All OK.
scientia non olet · About LEMON Manuals