Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Verify DTC P0191, P0192, P0193 is not set.
- If any of the DTCs are set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- If none of the DTCs are set
Perform the scan tool control function: Fuel Pressure Regulator 2 - On and Off
Verify the scan tool parameter:
- Fuel Pressure Regulator 2 Control Circuit High Voltage Test Status = OK or Not Run
- Fuel Pressure Regulator 2 Control Circuit Open Test Status = OK or Not Run
- Fuel Pressure Regulator 2 Control Circuit Low Voltage Test Status = OK or Not Run
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
All OK.