Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON.
Verify that DTC P0101, P0102, P0103, P0107, P0108, P0116, P0117, P0118, P0119, P0128, P0201, P0202, P0203, P0204, P020A, P020B, P020C, P020D, P0216, P02EE, P02EF, P02E8, P02E9, P02F0, P02F1, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0335, P0336, P062B, P062D, P111E, P122D, P1248, P1249, P124A, P124B, P126A, P16A0, P16A1, P16A2, P2147, P2148, P2150, P2151, P2228, P2229, P2230, P227C, P227D, or P227E is not set.
- If any of the DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- Go to next step: If none of the DTCs are set
Verify the scan tool BARO Sensor 2 parameter is within the range specified in the Altitude Versus Barometric Pressure table.
- If the parameter is not within the specified range
  Refer to Circuit/System Testing.
- Go to next step: If the parameter is within the specified range
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed in the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing.
- Go to next step: If the DTC does not set
All OK.