Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P2008, P2009, P2010, P2015, P2016, P2017 is not set.
- Perform the scan tool control function: Intake Manifold Runner Control Valve - Increase
Verify the scan tool parameter:
- Intake Manifold Runner Control Valve Control Circuit High Voltage Test Status = OK or Not Run
- Intake Manifold Runner Control Valve Control Circuit Open Test Status = OK or Not Run
- Intake Manifold Runner Control Valve Control Circuit Low Voltage Test Status = OK or Not Run
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Perform the scan tool control function: Intake Manifold Runner Control Valve - Increase & Decrease - 30 to 80%
Verify the scan tool parameter: Intake Manifold Runner Control Valve Feedback Signal = Intake Manifold Runner Control Valve Command
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.