Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition On
- Verify that no DTC listed in the DTC Descriptor Category is set.
- If a DTC Is set
Refer to Circuit/System Testing.
- Go to next step: If no DTC is set
- If a DTC Is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify that no DTC listed in the DTC Descriptor Category is set.
- If a DTC sets
Refer to Circuit/System Testing
- Go to next step: If a DTC does not set
- If a DTC sets
- All OK.