Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P206B
- DTC P1015, P1016, P1017, P1018, P1019, P101A, P206C, P206D, P2ADA, P2ADB, P2ADC, P2ADD, or U010E is not set.
- The ignition is on or the engine is running.
- The ignition voltage is greater than 11 V.
- The reductant tank temperature sensor 2 is greater than 5°C (41°F).
- The reductant level is greater than 5 L (1 gal).
The DTCs run continuously when the above conditions are met.
P206C, P206D
- DTC U010E is not set.
- The ignition is on or the engine is running.
- The ignition voltage is greater than 11 V.
The DTCs run continuously when the above conditions are met.