Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify that DTCs P205C, P205D, or U10E are not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- Go to next step: If none of the DTCs are set
- If any of the DTCs are set
- Engine running, verify that the Reductant Tank Temperature parameter reading is between -40 to +80°C (-40°F - 176°F).
- If not between -40 and +80°C (-40°F - 176°F)
Refer to Circuit/System Testing
- Go to next step: If between -40 and +80°C (-40°F - 176°F)
- If not between -40 and +80°C (-40°F - 176°F)
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- Go to next step: If no DTC sets
- If the DTC sets
- All OK.