LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Turbocharger Wastegate Actuator Vacuum Control Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Turbocharger Wastegate Actuator Vacuum Control Solenoid Valve And Components
    GM4182475Courtesy of GENERAL MOTORS COMPANY
  1. Install Turbocharger Wastegate Actuator Vacuum Control Solenoid Valve (5)
    2. CAUTION:

    Refer to Fastener Caution

  2. Install and tighten Turbocharger Wastegate Actuator Vacuum Control Solenoid Valve Bolts (2) (Qty: 2) to 10 N.m (89 lb in)
  3. Connect Power Brake Booster Vacuum Pipe (4)
  4. Connect Turbocharger Wastegate Actuator Pipe (3)
  5. Connect Electrical Connector (1)
  6. Install Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
scientia non olet · About LEMON Manuals