LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Piston Oil Nozzle Oil Control Solenoid Valve Replacement (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Piston Oil Nozzle Oil Control Solenoid Valve, Bolts And Electrical Connector
    GM4197172Courtesy of GENERAL MOTORS COMPANY
  1. Install Piston Oil Nozzle Oil Control Solenoid Valve (3)
    2. CAUTION:

    Refer to Fastener Caution

  2. Install and tighten Piston Oil Nozzle Oil Control Solenoid Valve Bolts (1) (Qty: 2) to 10 N.m (89 lb in)
  3. Connect Electrical Connector (2)
  4. Install Exhaust Front Pipe. Refer to Exhaust Front Pipe Replacement (LH7)
  5. Remove the supports and lower the vehicle. Refer to Lifting and Jacking the Vehicle
  6. Connect Battery Negative Cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
scientia non olet · About LEMON Manuals