Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install Oil Pump Flow Control Solenoid Valve (2)
- Install and tighten Oil Pump Flow Control Solenoid Valve Bolt (3) to 10 N.m (89 lb in)
- Connect the electrical connector. (1)
- Remove the supports and lower the vehicle. Refer to Lifting and Jacking the Vehicle
- Exhaust Front Pipe. Refer to Exhaust Front Pipe Replacement (LH7)
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
CAUTION:
Refer to Fastener Caution