LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Oil Pump Flow Control Solenoid Valve Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Pump Flow Control Solenoid Valve, Bolt And Electrical Connector
    GM4197158Courtesy of GENERAL MOTORS COMPANY
  1. Install Oil Pump Flow Control Solenoid Valve (2)
    2. CAUTION:

    Refer to Fastener Caution

  2. Install and tighten Oil Pump Flow Control Solenoid Valve Bolt (3) to 10 N.m (89 lb in)
  3. Connect the electrical connector. (1)
  4. Remove the supports and lower the vehicle. Refer to Lifting and Jacking the Vehicle
  5. Install Power Transfer Unit Case. Refer to Power Transfer Unit Case Replacement (MHG Transmission with LH7 Engine)
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
scientia non olet · About LEMON Manuals