LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Intake Air Pressure And Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
  2. Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
    3. Fig 1: Intake Air Pressure And Temperature Sensor, Bolt And Electrical Connector
    GM3283892Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the electrical connector (1) from the intake air pressure and temperature sensor (3).
  4. Remove the intake air pressure and temperature sensor bolt (2).
  5. Remove the intake air pressure and temperature sensor (3) from intake manifold (4).
scientia non olet · About LEMON Manuals