LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Fuel Tank Fuel Pump Module Replacement (FWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING:

Refer to Diesel/Gasoline Vapors Warning .

WARNING:

Refer to Safety Glasses Warning .

  1. Remove Fuel Tank. Refer to Fuel Tank Replacement (FWD) 
    2. Fig 1: Electrical Connectors, Fuel Pump Fuel Return Hose, Fuel Pump To Fuel Filter Hose And Fuel Tank Vent
    GM4673672Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect Electrical Connectors (1) (Qty: 2)
  3. Disconnect Fuel Pump Fuel Return Hose (2). Refer to Plastic Collar Quick Connect Fitting Service 
  4. Disconnect Fuel Pump to Fuel Filter Hose (3). Refer to Plastic Collar Quick Connect Fitting Service 
  5. Disconnect Fuel Tank Vent (4). Refer to Plastic Collar Quick Connect Fitting Service 
    6. Fig 2: Fuel Pump Lock Ring
    GM4673676Courtesy of GENERAL MOTORS COMPANY
  6. Remove Fuel Pump Lock Ring (1) - CH 52075  Fuel Sender Lock Ring Wrench
    7. Fig 3: Fuel Tank Vent Hose
    GM4673679Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect Fuel Tank Vent Hose (1). Refer to Plastic Collar Quick Connect Fitting Service 
    8. Fig 4: Fuel Tank Fuel Pump Module And O-Ring
    GM4673677Courtesy of GENERAL MOTORS COMPANY
  8. Remove Fuel Tank Fuel Pump Module (1)
  9. Remove and DISCARD O-Ring (2)
scientia non olet · About LEMON Manuals