LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Fuel Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Fuel Pressure Sensor
    GM4585062Courtesy of GENERAL MOTORS COMPANY
  1. Install NEW Fuel Pressure Sensor (1) - Hand tighten
    2. CAUTION:

    Refer to Component Fastener Tightening Caution

  2. Tighten Fuel Pressure Sensor (1) to 35 N.m (26 lb ft)
    3. Fig 2: Electrical Connector
    GM4585061Courtesy of GENERAL MOTORS COMPANY
  3. Connect Electrical Connector (1)
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
  5. Start the engine and check for fuel leaks.
  6. Install Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
  7. If replacing, perform the fuel injection small quantity learn. Refer to Fuel Injection Small Quantity Learn 
scientia non olet · About LEMON Manuals