Removal Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
Refer to Diesel/Gasoline Vapors Warning
WARNING:
Refer to Safety Goggles and Fuel Warning
CAUTION:
Clean all fuel pipe and hose connections and surrounding areas before disassembling to avoid possible contamination of the fuel system. Spray the fuel pump module cam-lock ring tang with penetrating oil prior to attempting removal.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
- Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
- Remove Fuel Injection Fuel Feed Pipe Bracket Bolt (1)
- Loosen Fuel Injection Fuel Feed Pipe (2) @ Fuel Rail (3)
- Loosen Fuel Injection Fuel Feed Pipe (2) @ Fuel Injection Pump (4)
- Remove and DISCARD Fuel Injection Fuel Feed Pipe (2)
- Close the fuel rail using suitable closure plugs.
NOTE:
Counterhold at the fuel injection pump hexagon connector.