LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Exhaust Temperature Sensor Replacement - Position 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING:

Refer to Exhaust Service Warning

WARNING:

Refer to Protective Goggles and Glove Warning

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
    3. Fig 1: Electrical Connector And Exhaust Temperature Sensor
    GM4725650Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect Electrical Connector (1) @ Exhaust Temperature Sensor (2)
    4. Fig 2: Exhaust Temperature Sensor And Retainer
    GM4725651Courtesy of GENERAL MOTORS COMPANY
  4. Unclip Exhaust Temperature Sensor (1) @ Retainer (2)
    5. Fig 3: Exhaust Temperature Sensor
    GM4725691Courtesy of GENERAL MOTORS COMPANY
  5. Remove Exhaust Temperature Sensor (1)
scientia non olet · About LEMON Manuals