LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Exhaust Temperature Sensor Replacement - Position 1 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
    2. Fig 1: Exhaust Temperature Sensor Electrical Connector And Retainers
    GM4421803Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect Exhaust Temperature Sensor Electrical Connector (2)
  3. Remove Exhaust Temperature Sensor Electrical Connector (3) @ Wiring Harness Retainer (1)
  4. Remove Wiring Harness Retainers (4) (Qty: 2)
    5. Fig 2: Exhaust Temperature Sensor - Position 1 And Retainers
    GM4421804Courtesy of GENERAL MOTORS COMPANY
  5. Remove Wiring Harness Retainers (1) (Qty: 2)
  6. Remove Exhaust Temperature Sensor - Position 1 (2)
scientia non olet · About LEMON Manuals