LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Exhaust Pressure Differential Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove Engine Control Module. Refer to Engine Control Module Replacement 
    2. Fig 1: Exhaust Pressure Differential Sensor Electrical Connector
    GM4175067Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect Electrical Connector (1) @ Exhaust Pressure Differential Sensor
    3. Fig 2: Exhaust Pressure Differential Sensor, Bolt, Hoses And Clamps
    GM4175068Courtesy of GENERAL MOTORS COMPANY
  3. Remove the exhaust pressure sensor hose clamps. (3) (Qty: 2)
    4. NOTE:

    Mind the difference hose diameters.

  4. Remove the exhaust pressure sensor hoses. (4) (Qty: 2)
  5. Remove Exhaust Pressure Differential Sensor Bolt (2)
  6. Remove Exhaust Pressure Differential Sensor (1)
scientia non olet · About LEMON Manuals