Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install and tighten Exhaust Gas Recirculation Cooler Temperature Sensor - Position 2 (2) to 45 N.m (33 lb ft)
- Connect Exhaust Gas Recirculation Cooler Temperature Sensor Electrical Connector (1)
- If replacing, perform the exhaust gas temperature sensor reset. Refer to Exhaust Gas Temperature Sensor Reset
- If replacing, perform the NOx catalyst reductant loading reset. Refer to NOx Catalyst Reductant Loading Reset
NOTE:
The guide lug (3) must fit the groove.
CAUTION:
Refer to Fastener Caution