LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Exhaust Gas Recirculation Cooler Outlet Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exhaust Gas Recirculation Cooler Temperature Sensor - Position 2 And Electrical Connector
    GM4376997Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the electrical connector. (1)
  2. Remove Exhaust Gas Recirculation Cooler Temperature Sensor (2)
    3. Fig 2: Exhaust Gas Recirculation Cooler Outlet Pipe, Bolts And Gaskets
    GM4377020Courtesy of GENERAL MOTORS COMPANY
  3. Remove Exhaust Gas Recirculation Cooler Outlet Pipe Bolts (1) (Qty: 2) @ Intake Manifold
  4. Remove Exhaust Gas Recirculation Cooler Outlet Pipe Bolts (4) (Qty: 2) @ Exhaust Gas Recirculation Cooler
  5. Remove Exhaust Gas Recirculation Cooler Outlet Pipe (5)
  6. Remove and DISCARD Exhaust Gas Recirculation Cooler Outlet Pipe Gasket (3)
  7. Remove and DISCARD Exhaust Gas Recirculation Cooler Outlet Pipe Seal (2)
scientia non olet · About LEMON Manuals