LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Engine Oil Pressure Sensor Replacement (FWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect Battery Negative Cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  3. Remove Exhaust Front Pipe. Refer to Exhaust Front Pipe Replacement (LH7)
    4. Fig 1: Engine Oil Pressure Sensor And Electrical Connector
    GM4197202Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the electrical connector. (2)
  5. Remove Engine Oil Pressure Sensor (1)
scientia non olet · About LEMON Manuals